Blendon Woods Socks by Kerri Blumer

Blendon Woods Socks

Knitting
January 2020
Fingering (14 wpi) ?
35 stitches and 48 rows = 4 inches
in Honeycomb 4 st repeat
US 1 - 2.25 mm
310 - 425 yards (283 - 389 m)
S (M, L, XL)
Flag of English English
This pattern is available for $6.00 USD buy it now

Blendon Woods Socks feature allover cables for a classic yet special design. A winding cable panel takes center stage, with allover honeycomb texture wrapping around the rest of the sock. There are four sizes so you can find your best fit - but make sure to size up from your typical stockinette sock stitch count since cables aren’t as stretchy. Show off your cabling expertise by letting these socks peek out of the top of ankle boots!

This pattern assumes knowledge of working in the round, basic cables, and basic sock construction. Both charts and written directions are provided for all stitch patterns.

Suggested Yarn: 21 Bridges Studio Go To Sock, or other fingering weight yarn that knits to gauge

Sizes: S (M, L, XL) to fit lower leg circumference up to 10.75 (12, 13.25, 14.75)” / 27.5 (30.5, 33.5, 37.5) cm
(Measure around your lower calf area, where the top of your sock cuff would sit)

Fit Note: due to the allover cables on this sock, choose a cast-on number that is higher than your typical stockinette sock. The sample is shown in the 72 st cast on, on a foot that usually wears a 64 st stockinette sock.

Yarn Requirements: 310 (345, 385, 425) yds / 284 (316, 352, 389) m

Gauge: 35 sts and 48 rows = 4” / 10 cm in Honeycomb 4 st repeat

Needles and Notions: US size 1 / 2.25 mm DPNs, cable needle, stitch markers, stitch holder, tapestry needle